Frigidaire FDR30S1ENG11 Dehumidifier Manual

The Frigidaire FDR30S1ENG11 is a 30-pint capacity dehumidifier designed for residential use, featuring electronic controls, an auto-restart function, continuous drain option, washable filter, and a built-in humidistat for precise moisture control. It operates on standard 115V AC power and is ideal for rooms up to 500 square feet. Below are key sections covering safety, features, installation, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Electronic control panel, Water tank with full indicator, Continuous drain port, Washable air filter, Built-in humidistat, Auto-defrost function.

Installation & Placement

Unpack and inspect contents. Choose appropriate location for optimal performance.

1. Clear area: Ensure at least 12 inches of clearance on all sides for proper airflow.
2. Level surface: Place on flat, stable surface to prevent vibration and noise.
3. Power source: Plug into dedicated 115V AC outlet; avoid extension cords.
4. Drain setup: For continuous drainage, attach hose to drain port and route to floor drain.

WARNING! Do not place near heat sources or in direct sunlight. Ensure room temperature is between 65°F and 90°F for proper operation.

First-Time Setup

Power on unit; configure initial settings.

1. Insert filter: Ensure washable filter is properly installed in front grille.
2. Set humidity level: Press HUMIDITY button to set desired level (recommended 45-50%).
3. Select fan speed: Choose HIGH for maximum dehumidification or LOW for quiet operation.
4. Test operation: Allow unit to run for 15 minutes to ensure proper cooling and drainage.

CAUTION! Handle water tank carefully when full. Empty tank before moving unit.

Specifications

• Model: FDR30S1ENG11
• Dehumidification Capacity: 30 pints/day (at 80°F, 60% RH)
• Water Tank Capacity: 1.8 gallons
• Coverage Area: Up to 500 sq. ft.
• Operating Temperature: 65°F to 90°F
• Humidistat Range: 35% to 85% RH
• Fan Speeds: 2 (High/Low)
• Power Requirements: 115V, 60Hz, 3.5A
• Refrigerant: R-410A
• Dimensions: 15.4" W × 11.4" D × 19.7" H
• Weight: 33 lbs

Controls and Settings

Control Panel: POWER, HUMIDITY (+/-), FAN SPEED, TIMER, FILTER RESET.

Display Indicators: Current humidity, Set humidity, Fan speed, Timer, Filter alert, Tank full.

Humidity Control: Adjust set point in 5% increments. Fan Control: Toggle between HIGH and LOW speeds. Timer: Program 24-hour on/off schedule. Filter Reset: Press after cleaning filter to reset reminder. Auto Defrost: Automatically activates when coil temperature drops below 41°F.

Operation Modes

Normal Mode: Runs continuously until set humidity is reached. Continuous Mode: Runs continuously regardless of humidity setting (for very damp areas). Timer Mode: Automatically turns unit on/off at programmed times.

1. Press POWER to turn unit on.
2. Set desired humidity level using HUMIDITY buttons.
3. Select fan speed (HIGH for faster dehumidification).
4. For continuous operation, set humidity to lowest setting (35%).

Tip: Close windows and doors for most efficient operation.

Maintenance & Cleaning

Regular maintenance ensures optimal performance and longevity.

1. Clean filter: Remove and wash filter every 2 weeks in warm water; dry completely before reinstalling.
2. Empty tank: Regularly check and empty water tank when full indicator lights.
3. Clean exterior: Wipe cabinet with soft, damp cloth; never use harsh chemicals.
4. Clean coils: Use soft brush to remove dust from rear coils annually.
5. Check drain hose: Ensure continuous drain hose is clear of obstructions.

WARNING! Always unplug unit before performing any maintenance. Do not use water to clean electronic controls.

Drainage Options

Bucket Drainage: Unit automatically shuts off when tank is full (indicator lights). Continuous Drainage: Connect 5/8" ID garden hose to drain port for unattended operation.

1. For bucket drainage: Ensure tank is properly seated and empty when full.
2. For continuous drainage: Attach hose, route to floor drain, and ensure downward slope.
3. Gravity drain only: Do not pump water upward; maximum hose length 10 feet.

Care & Storage

When not in use for extended periods, prepare unit for storage.

1. Unplug unit and empty water tank completely.
2. Clean filter and allow to dry thoroughly.
3. Clean cabinet and coils with soft cloth.
4. Coil drain pan: Run unit in fan-only mode for 30 minutes to dry internal components.
5. Store in cool, dry place; cover to prevent dust accumulation.

CAUTION! Never store unit with water in tank. Store in upright position.

Regulatory Information

UL Listed: Meets UL standard 474. Energy Star: Certified for energy efficiency. FCC Part 15: Class B digital device; complies with interference limits. Refrigerant: Contains R-410A; EPA certified technicians required for servicing. For support, visit www.frigidaire.com or contact 1-800-374-4432.

Troubleshooting

Reset: Unplug unit for 5 minutes to reset electronic controls.

Service: 1-800-374-4432; www.frigidaire.com