The Frigidaire FDL70S1ENG13 is a 70-pint dehumidifier designed for residential use, featuring automatic humidity control, continuous drainage capability, a washable air filter, a full tank alert with auto shut-off, and a 24-hour timer. It operates on 115V/60Hz power and is suitable for areas up to 4500 sq. ft. Below are key sections for safety, features, installation, operation, maintenance, and troubleshooting.
Key components: Control Panel, Water Tank, Air Filter, Drain Hose Connector, Casters for mobility, and Power Cord.
| Feature | Description |
|---|---|
| Humidity Control | Automatic with adjustable set point (35% - 85% RH) |
| Water Tank Capacity | Removable 16.9-pint bucket with handle |
| Full Tank Alert | Indicator light and auto shut-off when tank is full |
| Continuous Drainage | Garden hose adapter for permanent drainage |
| Air Filter | Washable mesh filter for improved air quality |
| Timer Function | 24-hour programmable on/off timer |
| Fan Speeds | Two-speed fan control (High/Low) |
| Defrost Function | Auto defrost for low-temperature operation |
| Mobility | Four casters for easy room-to-room movement |
| Power Indicator | LED light shows unit is powered on |
Unpack and inspect contents. Place on a level, stable floor.
WARNING! Do not operate in temperatures below 41°F (5°C). Ensure the air filter is clean before first use.
Access all functions via the electronic control panel on top of the unit.
Control Panel: POWER button, HUMIDITY SET buttons (+/-), FAN SPEED button (High/Low), TIMER button, FILTER ALERT indicator, FULL TANK indicator.
Basic Operation: Press POWER. Set desired humidity level using +/- buttons. The compressor and fan will run automatically to reach the set point, then cycle on/off to maintain it. Select fan speed for desired airflow and noise level. Use the TIMER to program automatic shut-off or start-up.
Indicators: FILTER ALERT light illuminates when the air filter needs cleaning. FULL TANK light illuminates and unit shuts off when the water bucket is full.
Two methods for removing collected water: Manual via bucket or Continuous via hose.
Tip: For continuous drainage, the unit must be level and the hose must not have kinks or upward loops.
Regular maintenance ensures optimal performance and longevity.
CAUTION! Always unplug the unit before performing any maintenance.
Proper storage is required if the unit will not be used for an extended period.
WARNING! Do not store the unit on its side or upside down, as this may damage the compressor.
This appliance complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. This product contains refrigerants. Disposal must comply with federal and local regulations. For service or support, contact Frigidaire at 1-800-374-4432 or visit www.frigidaire.com.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Unit does not start | No power / Full tank | Ensure plug is secure. Check if FULL TANK light is on; empty bucket. |
| Little or no water collection | Low humidity / Cold room / Dirty filter | Set lower humidity. Room temp must be above 41°F. Clean air filter. |
| Unit runs constantly | High humidity / Leaks / Incorrect setting | Normal in very damp conditions. Check for open windows/doors. Verify humidity set point. |
| Loud or unusual noise | Uneven surface / Loose parts | Place unit on level floor. Ensure bucket and filter are seated correctly. |
| FILTER ALERT light is on | Dirty air filter | Clean the air filter and reset the alert. |
| Error Code "E1" or "E2" | Sensor fault | Unplug for 10 minutes, then restart. If persists, contact service. |
Reset: Unplug the unit for 10 minutes to reset the electronic controls.
Service: 1-800-374-4432; www.frigidaire.com