Frigidaire FDD60J Dehumidifier Manual

The Frigidaire FDD60J is a high-capacity 60-pint dehumidifier designed for medium to large rooms, featuring automatic humidity control, continuous drain option, washable air filter, electronic controls with digital display, auto-restart after power interruption, and 24-hour timer. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Drainage 7. Operation Modes 8. Maintenance & Cleaning 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Electronic control panel, Digital humidity display, Water collection bucket, Continuous drain hose connection, Washable air filter, Casters for mobility.

Feature	Description
Humidity Control	Automatic humidity sensing and adjustment
Digital Display	Shows current humidity level and settings
Continuous Drain	Option for hose connection for automatic water removal
Washable Filter	Removable and washable air filter for easy maintenance
Auto Restart	Resumes previous settings after power interruption
24-Hour Timer	Programmable on/off timer for energy efficiency
Full Bucket Alert	Indicator light and auto shut-off when bucket is full
Portability	Built-in handles and casters for easy movement
Energy Efficient	Energy Star certified for reduced power consumption
Quiet Operation	Designed for low noise levels during operation

Installation

Unpack and inspect contents. Place on level surface.

Position the unit: Place on flat, level surface away from walls and furniture for proper airflow.
Check clearance: Ensure at least 12 inches of clearance on all sides for optimal performance.
Install casters: Attach all four casters to bottom of unit for mobility.
Prepare drainage: Decide between bucket collection or continuous drain hose connection.
Plug into grounded electrical outlet.

WARNING! Do not place near heat sources or in direct sunlight. Ensure proper ventilation around unit.

First-Time Setup

Power on dehumidifier; follow control panel prompts.

Set desired humidity: Use UP/DOWN buttons to select humidity level (30-80% RH).
Select fan speed: Choose between HIGH and LOW fan settings.
Program timer: Set 24-hour timer for automatic operation if desired.
Check bucket: Ensure water collection bucket is properly seated and empty.
Test operation: Allow unit to run for 15 minutes to verify proper cooling and dehumidification.

CAUTION! Always handle with dry hands. Do not operate with damaged cord or plug.

Specifications

Capacity: 60 pints per day (at 60°F, 60% RH).
Coverage Area: Up to 1,500 square feet.
Operating Temperature: 41°F to 95°F (5°C to 35°C).
Water Bucket Capacity: 16 pints (removable).
Power Requirements: 115V, 60Hz, 7.5 Amps.
Air Flow: 165 CFM (High setting).
Noise Level: 52 dB (Low setting).
Dimensions: 15.4" W × 11.4" D × 24.3" H.
Weight: 46.3 lbs.
Refrigerant: R-410A.

Controls and Settings

Access all functions via electronic control panel. Front Panel: POWER, HUMIDITY SET, FAN SPEED, TIMER, FILTER RESET.

Display Indicators: Current humidity, Set humidity, Timer status, Filter alert, Full bucket alert, Fan speed.

Humidity Control: Set desired level (30-80% RH) - unit cycles automatically to maintain setting. Fan Speed: HIGH for maximum dehumidification, LOW for quiet operation. Timer: Program on/off times in 1-hour increments up to 24 hours. Filter Reset: Press after cleaning air filter to reset maintenance reminder. Continuous Drain: Connect hose to rear port for automatic water removal.

Connecting Drainage

Two drainage options: Water bucket collection or continuous drain hose.

Bucket Method: Ensure bucket is properly seated; empty when FULL indicator lights.
Continuous Drain: Attach 5/8" ID hose to drain port at rear of unit.
Route hose: Ensure hose runs downward to floor drain or suitable container.
Check flow: Verify water flows freely without kinks or obstructions.

Tip: For continuous operation, use hose connection to prevent frequent bucket emptying.

Operation Modes

Supports automatic humidity control, continuous operation, and timer programming.

Automatic Mode: Set desired humidity level; unit cycles on/off to maintain setting.
Continuous Mode: Set to lowest humidity setting for maximum moisture removal.
Timer Operation: Program unit to turn on/off at specific times for energy savings.
Fan Only: Circulates air without dehumidification (when humidity is at set level).
Auto Defrost: Automatically defrosts coils when operating in low temperatures.
Bucket Full Protection: Auto shut-off when bucket is full; indicator light illuminates.

WARNING! Do not operate below 41°F (5°C) as coils may freeze. Use in heated spaces only.

Maintenance & Cleaning

Unplug before maintenance. Regular cleaning ensures optimal performance.

Clean Air Filter: Remove and wash filter every 2 weeks or as needed with warm water.
Empty Water Bucket: Empty regularly; clean with mild detergent monthly.
Clean Exterior: Wipe with soft, damp cloth; do not use abrasive cleaners.
Check Drain Hose: Ensure continuous drain hose is clear of obstructions.
Off-Season Storage: Empty all water, clean thoroughly, and store in dry location.

CAUTION! Never use harsh chemicals or immerse unit in water. Allow filter to dry completely before reinstalling.

Regulatory Information

UL Listed: Certified for safety standards. Energy Star: Meets energy efficiency guidelines. EPA Refrigerant: Uses R-410A, an environmentally friendly refrigerant. Copyright © Frigidaire; trademarks of Electrolux Home Products, Inc. For support, visit www.frigidaire.com or contact 1-800-374-4432. Two-year limited warranty on parts and labor.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Unit not starting	Power/Bucket full	Check power connection; empty water bucket; reset circuit breaker.
Poor dehumidification	Filter/Temperature	Clean air filter; ensure room temperature above 41°F; check doors/windows closed.
Water leakage	Bucket/Hose connection	Ensure bucket properly seated; check hose connections; level the unit.
Loud noise	Vibration/Obstruction	Place on level surface; check for objects touching unit; ensure fan is clean.
Display not working	Power/Control issue	Unplug for 5 minutes then restart; check power source; contact service if persists.
Ice on coils	Low temperature	Turn unit off until ice melts; increase room temperature above 41°F.
Filter light on	Dirty filter	Clean air filter; press FILTER RESET button for 3 seconds.

Reset: Unplug for 5 minutes to reset electronic controls.

Service: 1-800-374-4432; www.frigidaire.com